Now up and operational is our indoor carpet race track and also now the oudoor onroad asphalt race track as well. The outdoor track is 150x60/80 pending on the layout. The indoor track is 92x37 for electric indoor excitement.
2010/11 Debbie's RC World Carpet Class Rules
Rules/classes subject to change- You are viewing Draft #2, created 11 October 2010
***Change log- Draft #2 added linke to ROAR Sportsman ESC list for no-timing classes
Join our VERY active Discussion Thread on RCTech
General Raceday Schedule
Doors open 9a.m. for setup and practice
Registration Closes 10a.m.
Driver/Club Meeting at 10a.m. (no practice)
3 Qualifying Heat rounds start at 10:30a.m.
Single Mains start at conclusion of Qualifying
Break lengths announced at the end of each round
Last heat turn marshals for first heat in each round, all other heats are marshaled by previous heat
Do your part to help the raceday run smoothly and timely!
Sportsman Stock Touring
17.5 ROAR Spec Brushless Motor
No-ESC Timing [ROAR spec profiles/ESCs. Updatable ESCs recommended if planning to move up in the future]
2s ROAR Approved [Hard case] LiPo, 8.40V MAX starting voltage
Pre-mounted Spec Rubber tire - TBD
No Sponsored Drivers
5mm Minimum Ride Height
190mm Max track width [measured from edge of tire]
1420g Minimum Weight 1400g limit Proposed, -20g from 2010 ROAR rules
ROAR Approved Touring body, rear bumper must be intact
Heats and Races- 6 minutes
Superstock Touring
17.5 ROAR Spec Brushless Motor
Open ESC
2s ROAR Approved [Hard case] LiPo, 8.40V MAX starting voltage
Open Rubber Tire
5mm Minimum Ride Height
190mm Max track width [measured from edge of tire]
1420g Minimum Weight 1400g limit Proposed, -20g from 2010 ROAR rules
ROAR Approved Touring body, rear bumper must be intact
Heats and Races- 6 minutes
Muscle Car
190mm Touring Chassis
27t fixed timing Brushed motor [rebuildable motors allowed]
2s ROAR LiPo [8.40V MAX] or 6cell NiMh Battery
Pre-mounted Spec Rubber Tire - Jaco Blue
5mm Minimum Ride Height
1450g Minimum Weight
American Muscle Car body, driver figure not required
Heats and Races- 5 minutes
Vintage Trans-Am
See National VTA rules here.
World GT
200mm width 1/10 scale 2wd Pan car
1s ROAR Approved LiPo, hardcase [4.20V MAX starting voltage]
WGT Spec Foam Tires
13.5 ROAR Spec Motor
Open ESC
4mm Minimum Ride Height [starting, spur gear not included]
205mm Max Track Width
WGT Approved Body
930g Minimum weight
Heats and Races- 8 minutes
Sportsman/Stock 1/12
1/12 scale Pan car
1s ROAR approved LiPo
17.5 ROAR Spec Motor
No-ESC Timing [ROAR spec profiles/ESCs. Updatable ESCs recommended if planning to move up in the future]
Open Foam Tire
3mm Minimum Ride Height [starting, spur gear not included]
172mm Max track width
730g Minimum weight
Heats and Races- 8 minutes
Expert 1/12
1/12 scale Pan car
1s ROAR approved LiPo
10.5 ROAR Spec Motor
Open ESC
Open Foam Tire
3mm Minimum Ride Height [starting, spur gear not included]
172mm Max track width
730g Minimum weight
Heats and Races- 8 minutes
Legends
RJ Speed or Bolink Legends chassis
Legends body
27t brushed motor and ESC
Kit spur, 81t (48p), 17t pinion (48p)
6cell NiMH pack (with any battery connector, no direct soldering)
Open tires
Steel rear axle required
Bearings allowed
Turnbuckles allowed
Front suspension open, but must retain 1/8" kingpin (stock) and front suspension plates (no camber adjustment)
All chassis cross braces must be installed [6 total], may be made of any material
No weight limits
Front bumper required
No ride height limits, but body must be mounted in stock manner
Heats and Races- 5 minutes
